California Instruments 1251RP Series Manual de usuario descargar pdf

••

• Certified IEC Compliance

Certified by the National Physics Laboratory in the

United Kingdom for full compliance with the IEC

Harmonics and Flicker standards.

••

• PC Based IEC Test System

High speed PC Based data acquisition system

streams all data to disk.

••

• Field Upgradable

Software only upgrades to meet future

standard requirements

••

• IEC 61000-3-2 Harmonics

••

• IEC 61000-3-3 Flicker

••

• IEC 61000-4-11 Voltage Dips

and Variations

••

• IEC 61000-4-13 Harmonics

& Interharmonics

••

• IEC 61000-4-14 Voltage Fluctuations

••

• IEC 61000-4-17 DC Ripple

••

• IEC 61000-4-28 Frequency Variations

IEC Compliance

Test Systems

CTS Series

Unique Features

• Single and Three phase systems

to accommodate a range of power

levels.

• Direct PC bus access data acqui-

sition system provides high sam-

pling rate and resolution for accu-

rate measurements and high

speed data transfers, even in three

phase mode.

• PC based harmonic and flicker test

software provides real-time full

color data display updates and

continuous PASS/FAIL monitoring.

• Support for both European and

Japanese standards.

• Simple user operation under Win-

dows 95/98

or Windows NT

, pro-

vides IEC test setup, data analy-

sis, display and reporting.

• High resolution, no gap acquisition

data storage to disk in ASCII for-

mat for post-acquisition analysis

and reporting.

• Single Step and Fast Forward re-

play of recorded test data.

Modular Architecture

The CTS system is a complete IEC

compliant test system, consisting of a

separate AC power source and a PC

based AC power analyzer.

• Programmable IEC compliant AC

power source in single or three

phase configurations.

• PC Based single or three phase

digital power analyzer (PC not in-

cluded).

• Choice of ISA, PCI or PCMCIA

based A/D cards to accommodate

desktop or laptop PC’s.

• Harmonics Analyzer and Flicker

meter software.

• Programmable reference imped-

ance per IEC 725 for Flicker and

Japanese Harmonics measure-

ments.

• Optional IEC 725 lumped flicker

reference impedance available for

European Flicker standard.

• Optional Electronic Output Switch

(EOS) to meet IEC 1000-4-11

source requirements.

Full Featured AC Power

Source

Available in a choice of power levels

ranging from 1250 VA to 30,000 VA,

CTS Systems cover the complete

range of single and three phase prod-

ucts that need testing to conform with

existing and pending IEC standards.

All iX Series AC sources meet IEC re-

quirements for low voltage distortion

and offer arbitrary waveform genera-

tion, precision measurements, and

waveform analysis capabilities.

All iX Series based CTS systems sup-

port full compliance IEC 61000-4 AC

immunity test as well (certain options

may be required).

The 1251RP source meets the same

requirements for low power loads with

crest factors less than three. AC

Source voltage distortion is measured

in real-time during the harmonics test

and any distortion that could affect the

test results is clearly indicated.

1 2 3 4 5 6 7 8

Indice de contenidos

Pagina 1 - CTS Series

••••• Certified IEC ComplianceCertified by the National Physics Laboratory in theUnited Kingdom for full compliance with the IECHarmonics and Flicker

Pagina 2

PC Bus Data AcquisitionA high speed digital signal processorbased data acquisition system is usedto implement the required IEC compli-ance measurement

Pagina 3 - Available Data Displays

CTS Series - IEC 61000-3-2 Harmonics TestSimple User InterfaceAll IEC Harmonics tests can be accessed from a singlecontrol and data display window on

Pagina 4 - Test Reports and Data Logging

CTS Series - IEC 61000-3-3 Flicker TestSimple User InterfaceThe Flicker test software module uses a similar user inter-face as the Harmonics module.

Pagina 5 - IEC 61000-4-13 Test Window

iX-Series based CTS systems are supplied with additional software that allows a series of AC immunity tests to beperformed on the unit under test. Pas

Pagina 6 - MS Word Test Reports

CTS Series - Report GenerationMS Word Test ReportsTest reports for harmonics, flicker andimmunity tests are generated using MSWord format. This widel

Pagina 7 - Signal Conditioning

The following specifications are valid forthe power analyzer portion of the CTS.PC Based A/D ConversionThe Harmonics Analyzer is imple-mented using a

Pagina 8 - PC Requirements

Ordering InformationPC RequirementsThe CTS requires the use of a PC ca-pable of running Windows 95/98® orWin NT 4.0/2000. For best perfor-mance, netw

Mas documentos para De medición, control y control California Instruments 1251RP Series

a Ver el documento California Instruments 1251RP Series Manual de usuario

California Instruments 1251RP Series Manual de usuario (12 paginas)

Comentarios a estos manuales

Sin comentarios

California Instruments 1251RP Series Manual de usuario

Busca en linea o descarga Manual de usuario para De medición, control y control California Instruments 1251RP Series. California Instruments 5001IX-CTS Datasheet Manual de usuario

Indice de contenidos

Mas documentos para De medición, control y control California Instruments 1251RP Series

Comentarios a estos manuales

Relacionado con productos y manuales para De medición, control y control California Instruments 1251RP Series