California Instruments 801RP Series Especificaciones descargar pdf (Pagina 112)

10.10.6 *RST

This command resets the AC source to a setting defined by the values in the register defined

by PON if valid or by the following factory-defined states:

Table 10-4: *RST Default Parameter Values

Item

Value

Item

Value

VOLT

5.0 V

FREQ

60 Hz

CURR

5.0 A

VOLT:RANGe:LEVel

135 V

VOLT:RANGe:AUTO

0 (OFF)

OUTP

0 (OFF)

DISP:MODE

1 (FREQ)

OUTP:STARt:STATe

0 (OFF)

OUTP:STARt:PHASe

NOTE: The factory defaults cannot be used on units with the -AV option. Instead, one

of the setup registers 0 through 7 must be selected for the power on state.

Executing the *RST command will recall the settings from the assigned setup

the power on and *RST states.

Command Syntax *RST

Parameters None

Related Commands *SAV

Table 10-5: Status Registers - Power on Conditions

Status on Power On

Status after *RST

- ESE register

All 0‟s

- ESR register

PON bit = 1, all others 0

PON = 0, all others unaffected

- STB register

All 0‟s

- SRE register

All 0‟s

Note: Sending the *RST command will cause the unit to recall the REMOTE or LOCAL state

based on the setting of the SYSTem:KLOCk command. This may put the unit in local if this

state is set to 0. To avoid this, either set the SYSTem:KLOCk state to 1 or follow the *RST

command with a SYST:REM command. See SYSTem:KLOCk for information on the power

up remote / local state.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 125 126

Comentarios a estos manuales

Sin comentarios

California Instruments 801RP Series Especificaciones Pagina 112

Comentarios a estos manuales

Relacionado con productos y manuales para De medición, control y control California Instruments 801RP Series