California Instruments 2253iX Manual de instrucciones descargar pdf (Pagina 10)

Programming Manual Compact i / iX Series

AMETEK Programmable Power Division 10

The above two documents are available from the IEEE (Institute of Electrical and Electronics

Engineers), 345 East 47th Street, New York, NY 10017, USA or via the web at www.ieee.org

1.2 Compact i and iX Series Differences

The compact i and iX Series of AC power sources are both based on the same AC power source

hardware platform and share many common components. The differences are primarily in

configuration and options. This manual covers both model series. Some commands listed may

not apply to i Series AC sources. Where relevant, the “iX only” comment is used to indicate that

specific commands apply only to iX models.

1.2.1 Phase Selection

Single phase models 751 and 1501 do not support any of the phase selection commands listed in

this programming manual. These models only have a Phase A output and no phase selection is

possible. Phase selection commands are INST:NSEL and INST:COUP. These commands apply

only to the 2253i and 2253iX three phase models. SCPI Commands that can be used to operate

on a specific phase are indicated with the “Phase Selectable” phrase below the command syntax.

This means that on a 2253i/iX, using the INST:NSEL and INST:COUP will determine if a specific

phase or all phases will be affected when the command is executed. Other commands such as

measurement queries only apply to one phase at a time regardless of the INST:COUP setting.

For these commands, INST:NSEL is required to change between phases.

1.2.2 Firmware differences

The iX Series is fully featured and supports all commands listed in the programming manual.

The i Series provides most basic functions in its standard configurations. On i series models,

commands related to arbitrary waveforms and harmonic analysis measurements are not

supported and will generate a “-113 Syntax Error” message.

1.2.3 Hardware differences

In addition to the firmware differences described, the following hardware differences exist

between the standard iX Series AC source and the i Series AC source.

• The iX Series comes standard with both GPIB and USB interfaces. An optional Ethernet

interface (-LAN option) is available.

• The i Series comes standard with USB only. An optional GPIB interface (-GPIB option) is

available.

• The 2253i and 2253iX are equipped with an RS234 interface in addition to USB.

However, only one interface can be used at a time and connecting the USB interface to a

PC will disable the RS232 port (and LAN option if installed on 2253iX).

Note: All interfaces use the SCPI command syntax as described in this programming manual.

1.3 Manual organization and format

All user documentation for California Instruments power sources is provided on CDROM in

electronic format. (Adobe Portable Document Format) The required Adobe PDF viewer is

supplied on the same CDROM. This manual may be printed for personal use if a hardcopy is

desired. To request a hardcopy from AMETEK Programmable Power Division, contact customer

service at [email protected]

. There will be an additional charge for printed manuals.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 215 216

Comentarios a estos manuales

Sin comentarios

California Instruments 2253iX Manual de instrucciones Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para De medición, control y control California Instruments 2253iX