California Instruments 2253iX Manual de instrucciones descargar pdf (Pagina 29)

Programming Manual Compact i / iX Series

AMETEK Programmable Power Division 29

3.4.3 Private Networks without DHCP servers

If you are setting up a private network that connects the power source to a Windows PC using a

so called cross over RJ45 cable, the PC will assign itself an IP address in the absence of a

DHCP server. The available IP address range assigned by the Internet Assigned Network

Authority (IANA) for Automatic Private IP Addressing (APIPA) is 169.254.0.0 to 169.254.255.255.

When setting up a private network, you will have to log off and disconnect first from any network

connection and re-log in to Windows.

To check the PC’s IP address, you can run the “ipconfig.exe” program from the command

prompt. The screen on a private network should look as follows:

Microsoft(R) Windows DOS

(C)Copyright Microsoft Corp 1990-2001.

C:\>ipconfig

Windows IP Configuration

Ethernet adapter Local Area Connection:

Connection-specific DNS Suffix . :

IP Address. . . . . . . . . . . . : 169.254.0.208

Subnet Mask . . . . . . . . . . . : 255.255.0.0

Default Gateway . . . . . . . . . :

Since there is no DCHP server present in a private network like this, the power source has to be

set to a static IP address. To determine what IP address to use, use the first 2 octets of the PC’s

IP address and set a unique value for the third and fourth octet as long as there are no conflicts

with any other IP addresses (other instruments) on the same private network. In this example,

169.254.0.209 would work.

Note: For private network configurations, no Gateway address is required. (0.0.0.0)

3.4.4 Setting LAN Parameters

There are two ways to set the required LAN information on the power source.

1. Through Ethernet connection:

Use the “GetAssignIPAddress.exe” Windows utility

program that is distributed on the CIC496 CD ROM with every power source. This uitility

uses the network connection to set parameters on the power source so the power source

and the PC will have to be connected to the same network through a hub or to each other

using a cross over network cable (local network).

2. Through Front Panel:

Set the parameters from the front panel CONFIGURATION menu.

In this case, connection to a network is not required to set the LAN parameters.

To use the CONFIGURATION menu, press the MENU and use the up/down error keys to display

the CONFIGURATION entry. Place the pointer on CONFIGURATION and press the ENTER key.

Then scroll down till you see LANetwork and press ENTER again.

The following fields are available in the LANetwork menu:

Menu Values Description

LANetwork LAN If the LAN option is installed; pressing Enter while

the cursor is on the LANetwork entry provides

access to the LAN interface settin

screens listed

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 215 216

Comentarios a estos manuales

Sin comentarios

California Instruments 2253iX Manual de instrucciones Pagina 29

Comentarios a estos manuales

Relacionado con productos y manuales para De medición, control y control California Instruments 2253iX