California Instruments 2253iX Manual de instrucciones descargar pdf (Pagina 162)

Programming Manual Compact i / iX Series

AMETEK Programmable Power Division 162

8. Option Commands

8.1 Introduction

The i and iX Series offer a number of options that are implemented in the power source

controller. If one or more of these options are installed, they can generally be used from both the

front panel and the interface. For front panel operation of any of these firmware options, consult

the User Manual supplied with the unit. For use in an automated test system, this chapter

contains the command sub system syntax for the available test options.

Note that some avionics test options like –ABD, -AMD and –B787 are implemented through the

included Windows GUI software only and do not have any front panel or bus commands

associated with them. For these options, refer to the “Avionics Software Manual”, CI P/N 4994-

971 supplied in Adobe Acrobat (PDF) format on the same distribution disk as this manual.

The AC power source will report all installed options, including any firmware options, when

queried using the SYST:CONF:BYTE? or *OPT? command. Additional firmware options may be

added over time. Consult the factory for additional information on firmware options not listed here

but present on your unit.

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 215 216

Sin comentarios

California Instruments 2253iX Manual de instrucciones Pagina 162