California Instruments 2253iX Manual de instrucciones descargar pdf (Pagina 30)

Programming Manual Compact i / iX Series

AMETEK Programmable Power Division 30

below.

IP Address Displays the IP address setting. This value can be

changed by pressing the SET key and entering a

new value from the keypad. Use the numeric data

pad or the voltage shuttle to enter each field. To

move between the four fields, use the decimal point

key on the keypad.

To set a fixed IP address, press SET and enter the

desired IP address. To set the unit to DHCP mode,

press SET and enter all zeros (0.0.0.0) as the IP

address and cycle power two times. The obtained

IP address will be displayed after the second power

on. For the DHCP setting to work however, the unit

MUST be connected to a network with a DHCP

server.

Any change to this value will NOT take effect until

after power on the unit has been cycled.

When changing mode from static IP to DHCP, it is

necessary to cycle power on the unit twice, once to

change mode and again to obtain and display a

new IP address from the network.

MAC Address Displays the network Media Acces Control

address. This value is fixed and cannot be

changed. The same MAC is normally printed on the

model serial tag. The MAC address is shown as six

hexadecimal numbers separated by a colon, e.g.

00:20:4A:9A:02:FD. Note that the leading ‘0’ is

never visible due to the maximum number of LCD

characters per line.

Note: If the MAC Address displayed is corrupted or

does not match the serial tag, there may have been a

problem retrieving the LAN port settings. This can

happen if a static IP was set that conflicts with

another device on the network. To recover, turn on

power to the unit while holding down the SET key.

This will allow the unit to boot without attempting to

collect the IP settings. You can then set the required

IP values. [See IP Address above].

GWAddress

Gateway address setting. A default gateway is a

node (a router) on a computer network that serves

as an access point to another network.

This value can be changed by pressing the SET

key and entering a new value from the keypad. Use

the numeric data pad or the Voltage shuttle to enter

each field. To move between the four fields, use

the decimal point key on the keypad.

Any change to this value will NOT take effect until

after power on the unit has been cycled.

HostBits Number of host bits as opposed to network bits in

network mask. A CIDR class C network uses 24

network bits and 8 host bits.

(

Class A = 24, Class B

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 215 216

Comentarios a estos manuales

Sin comentarios

California Instruments 2253iX Manual de instrucciones Pagina 30

Comentarios a estos manuales

Relacionado con productos y manuales para De medición, control y control California Instruments 2253iX