
Programming Manual Compact i / iX Series
AMETEK Programmable Power Division 189
MS704:POWer:FAIL[:COMBination]:TWO
This command will run the power fail state combination operation mode 2 test.
Command Syntax MS704:POWer:FAIL[:COMBinaton]:TWO
Parameters none
Examples MS704:POW:FAIL:TWO
Query Syntax none
MS704:POWer:FAIL:THRee
This command will run the power fail state combination operation mode 3 test.
Command Syntax MS704:POWer:FAIL:THRee
Parameters none
Examples MS704:POW:FAIL:THR
Query Syntax none
MS704:POWer:FAIL:PHASe:REVersal
This command will run the power fail state combination phase reversal test.
Command Syntax MS704:POWer:FAIL:PHASe:REVersal
Parameters none
Examples MS704:POW:FAIL:PHAS:REV
Query Syntax none
8.4.7 MS704 Transfer State Commands
Transfer state tests can be started by sending the MS704:TRAN command.
MS704:TRANsfer[:POWer][:INTerrupt]
This command will run the transfer power interrupt test.
Command Syntax MS704:TRANsfer[:POWer][:INTerrupt]
Parameters none
Examples MS704:TRAN
Query Syntax none
Comentarios a estos manuales